Door catch source?

edidin · Post by **edidin** » Wed Apr 20, 2022 2:57 pm

Anyone know where one can get new ones of the dual roller/spring catch fitted to the strut of a 120 to hold the door open?

Post by **6643** » Wed Apr 20, 2022 3:25 pm

Try Home Depot. That's off a 1950's vintage kitchen cabinet door.

6277 · Post by **6277** » Wed Apr 20, 2022 4:13 pm

That will no doubt work, but the proper part is a strap that fits around the strut. The strap has "stud" on the end that pokes into an opening on the bottom of the door. Inside the hole is a friction catch that captures the stud. Check page 20 of the parts manual.

edidin · Post by **edidin** » Wed Apr 20, 2022 9:14 pm

Thanks to both. After posted realized had seen as a kid on our old 1950s steel kitchen cabinets. Stock is the opposite apparently - catch through a hole in the door.

Post by **6643** » Thu Apr 21, 2022 8:06 am

I have a bucket full of the catches. Free if you pay postage and handling

The strap is easy enough to make.

: door clips.jpg (290.07 KiB) Viewed 1364 times

meloosifah · Post by **meloosifah** » Fri Apr 22, 2022 11:36 pm

I could use a pair of those door catches if they are not going to be used! Both of mine are worn out.

Post by **6643** » Sat Apr 23, 2022 6:47 am

meloosifah wrote: ↑Fri Apr 22, 2022 11:36 pm I could use a pair of those door catches.

Sent you a private message.

greenwr400f · Post by **greenwr400f** » Sun May 01, 2022 6:25 pm

John if you have any more of those catch's I need a couple please.

Cessna 120-140 Association

Door catch source?

Door catch source?

Re: Door catch source?

Re: Door catch source?

Re: Door catch source?

Re: Door catch source?

Re: Door catch source?

Re: Door catch source?

Re: Door catch source?

Who is online